Still receiving the old bill type? You're on the right page! If not, choose the correct FAQ.
How to install a decoder using the Wi-Fi booster?
Please note: before starting the synchronization of your Wi-Fi Booster, make sure that your modem is a b-box 3 or o-box 3 and that the Wi-Fi is activated..
Synchronization
- First, make sure the button at the back of the Wi-Fi Booster is in the AUTO position.
- Plug your Wi-Fi Booster into a power socket in the same room as your modem and press the Power button to start it. The WPS button flashes for 1 minute. Wait until the button stops flashing before proceeding to the next step.
- Keep the WPS button on the modem pressed for 2 seconds. Then, keep the WPS button on your Wi-Fi Booster pressed for 2 seconds. Both LEDs will flash and then go out. When the Link Quality LED stays lit, the synchronization is complete.
Installation
- Now that the Wi-Fi Booster is synchronized to the modem, you can unplug the Wi-Fi Booster.
- Plug it back in the room where you want to install your decoder, making sure that the POWER button is pressed down.
- CPlug one end of the Ethernet cable into one of the ports at the back of your Wi-Fi Booster. The other end of the Ethernet cable must be plugged in your decoder.
If you have followed all the steps correctly, the Power and Link Quality LEDs are green.